holder

The following is an abstract for the selected article. A PDF download of the full text of this article is available here. Members may download full texts at no charge. Non-members may be charged a small fee for certain articles.


Optimization of Single-Molecule Fluorescence Burst Detection of ds-DNA: Application to Capillary Electrophoresis Separations of 100-1000 Basepair Fragments

Volume 51, Number 10 (Oct. 1997) Page 1579-1584

Haab, Brian B.; Mathies, Richard A.


Methods for optimizing the dye labeling, laser excitation, and data analysis for single-molecule fluorescence burst detection of ds-DNA have been developed and then validated through capillary electrophoresis (CE) separations of 100-1000 basepair (bp) DNA. Confocal microscopy is used to observe fluorescence bursts from individual DNA fragments labeled with the intercalation dye TO6 as they pass through the ~ 2- mu m-diameter focused laser beam. The dye concentration and laser power were optimized by studying fluorescence burst intensities from pBluescript DNA fragments. The optimal TO6 concentration was 100 nM, and the optimal laser power was 1 mW. Single-molecule counting was then used to detect CE separations of a 100-1000 bp DNA sizing ladder in 3% linear polyacrylamide. Discrete and baseline-resolved fluorescence bursts were observed in bands as small as 100 bp, and the average burst size within each band increased linearly with fragment size. By counting events using a single optimally chosen discriminator level, we achieve maximum signal-to-noise ratio (S/N) for each fragment size. If the discriminator level is ramped linearly with fragment size to achieve a constant detection efficiency, then the number of events properly reflects the relative fragment concentrations.